Brocade Network OS Message Reference v4.1.1 - Manual (Page 128)

112 Network OS Message Reference
53-1003227-01
BL-1033
8
BL-1033
Message
(<slot string>,bitmap 0x<object control flags(bitmap)>) No disable acknowledgment
from ports (state <status of the interface module>). Disabling slot.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that the system has timed out waiting for the disable acknowledgment messages from the user
ports.
Recommended
Action
Reload or power cycle the interface module using the power-off and power-on commands.
Execute the diag systemverification command to verify that the interface module does not have
hardware problems.
Execute the diag post command to make sure that Power-On Self-Test (POST) is enabled.
If the message persists, replace the interface module.
BL-1034
Message
<slot string> CEE initialization completed.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified slot has completed initializing the Converged Enhanced Ethernet (CEE)
ports.
Recommended
Action
No action is required.
BL-1037
Message
Faulting chip in <slot string>, miniS = <mini-switch number>,port = <port number>
due to BE/BI port fault.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that all ports on the chip have been disabled due to a fault on the chip.
Recommended
Action
Execute the diag systemverification command to determine if there is a hardware error.
Execute the diag post command to make sure that Power-On Self-Test (POST) is enabled.