Brocade Network OS Message Reference v4.1.1 - Manual (Page 226)

210 Network OS Message Reference
53-1003227-01
FW-1035
8
FW-1035
Message
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the temperature of the small form-factor pluggable (SFP) transceiver has risen above the
high boundary.
Recommended
Action
Frequent fluctuations in temperature may indicate a deteriorating SFP transceiver. Replace the SFP
transceiver.
FW-1036
Message
<Label>, is between high and low boundaries(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the temperature of the small form-factor pluggable (SFP) transceiver has changed from a
value outside of the acceptable range to a value within the acceptable range.
Recommended
Action
No action is required.
FW-1038
Message
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the receive power value of the small form-factor pluggable (SFP) transceiver has fallen
below the low boundary. The receive performance area measures the amount of incoming laser to help
you determine if the SFP transceiver is in good working condition or not. If the counter often exceeds the
threshold, the SFP transceiver is deteriorating.
Recommended
Action
Verify that the optical components are clean and functioning properly. Replace deteriorating cables or
SFP transceivers. Check for damage from heat or age.