Brocade Network OS Message Reference v4.1.1 - Manual (Page 188)

172 Network OS Message Reference
53-1003227-01
FABR-1012
8
FABR-1012
Message
<function stream>: no such type, <invalid type>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the fabric is not in the appropriate state for the specified process. This message is rare and
usually indicates a problem with the Network OS.
Recommended
Action
The fabric daemon will take proper action to recover from the error.
If the message persists, execute the copy support command and contact your switch service provider.
FABR-1013
Message
No Memory: pid=<fabric process id> file=<source file name> line=<line number
within the source file>.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is
rare and usually indicates a problem with the Network OS.
Recommended
Action
The system will recover by failing over to the standby management module.
If the message persists, execute the copy support command and contact your switch service provider.
FABR-1014
Message
Port <port number> Disabled: RBridge IDs overlap. Insistent RBridge ID <RBridge
ID> could not be obtained. Principal is trying to assign RBridge ID <RBridge ID>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the switch received an RBridge ID other than the one it requested. The port was disabled
because the requested insistent RBridge ID could not be obtained.
Recommended
Action
Change the RBridge ID of the local node (if applicable) using the vcs rbridge-id command. You can
toggle the disabled port using the fabric isl enable and no fabric isl enable commands after the
RBridge ID change.