Brocade Network OS Message Reference v4.1.1 - Manual (Page 371)

Network OS Message Reference 355
53-1003227-01
RCS-1003
8
RCS Messages
RCS-1003
Message
Failed to allocate memory: (<function name>).
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified reliable commit service (RCS) function has failed to allocate memory.
Recommended
Action
This message is usually transitory. Wait for a few minutes and retry the command.
Check memory usage on the switch using the show process memory command.
Reload or power cycle the switch.
RCS-1005
Message
Phase <RCS phase>, <Application Name> Application returned <Reject reason>,
0x<Reject code>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that a receiving switch is rejecting the specified reliable commit service (RCS) phase.
Recommended
Action
If the reject is in acquire change authorization (ACA) phase, wait for several minutes and retry the
operation from the sender switch.
If the reject is in the stage fabric configuration (SFC) phase, check if the application license exists for the
local RBridge and if the application data is compatible.
RCS-1006
Message
State <RCS phase>, Application <Application Name> AD<Administrative RBridge>, RCS
CM. RBridge <RBridge ID that sent the reject> returned 0x<Reject code>. App
Response Code <Application Response Code>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified RBridge rejected the reliable commit service (RCS) phase initiated by an
application on the local switch.
• If the reject phase is acquire change authorization (ACA), the remote RBridge may be busy and
could not process the new request.
• If the reject phase is stage fabric configuration (SFC), the data sent by the application may not be
compatible or the RBridge does not have the license to support the specified application.