Brocade Network OS Message Reference v4.1.1 - Manual (Page 185)

Network OS Message Reference 169
53-1003227-01
FABR-1001
8
FABR Messages
FABR-1001
Message
port <port number>, <segmentation reason>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified switch port is isolated because of a segmentation resulting from mismatched
configuration parameters.
Recommended
Action
Based on the segmentation reason displayed in the message, look for a possible mismatch of relevant
parameters in the switches at both ends of the link.
FABR-1003
Message
port <port number>: ILS <command> bad size <payload size>, wanted <expected
payload size>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an internal link service (ILS) information unit of invalid size has been received. The
neighbor switch has sent a payload with an invalid size.
Recommended
Action
Investigate the neighbor switch for problems. Execute the show logging raslog command on the
neighbor switch to view the error log for additional messages.
Check for a faulty cable or deteriorated small form-factor pluggable (SFP) transceiver. Replace the cable
or SFP transceiver if necessary.
If the message persists, execute the copy support command and contact your switch service provider.
FABR-1004
Message
port: <port number>, req iu: 0x<address of IU request sent>, state: 0x<command
sent>, resp iu: 0x<address of response IU received>, state 0x<response IU state>,
<additional description>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the information unit (IU) response was invalid for the specified command sent. The fabric
received an unknown response. This message is rare and usually indicates a problem with the Network
OS kernel.