Brocade Network OS Message Reference v4.1.1 - Manual (Page 135)

Network OS Message Reference 119
53-1003227-01
C3-1004
8
C3 Messages
C3-1004
Message
<slot string>,C<chip index>: Invalid DMA ch pointer, chan:<channel number>,
good_addr:0x<good address> bad_addr:0x<bad address>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an internal error in the application-specific integrated circuit (ASIC) hardware that may degrade
the data traffic.
Recommended
Action
Reload the system at the next maintenance window. If the problem persists, replace the interface
module.
C3-1006
Message
<slot string>,C<chip index>: Various non-critical hardware errors were observed:
fault1:0x<fault1_count>, fault2:0x<fault2_count>, thresh1:0x<threshold used>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that some errors were found in hardware that may or may not impact the data traffic.
Recommended
Action
No action is required.
C3-1010
Message
<slot string>,C<chip index>: Above normal hardware errors were observed:
fault1:<fault1_count>, fault2:<fault2_count>, thresh2:0x<threshold used>.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that above normal errors were observed in hardware that may or may not impact the data
traffic.
Recommended
Action
Whenever this error is observed persistently, power cycle the specified interface module using the
power-off and power-on commands. If the problem persists, replace the interface module.