Bosch 8-Dec User Manual

Page 216

Advertising
background image

208 | Detectors and Accessories | Motion Long Range

Top View
Standard Long Range: 61 m x 3 m (200 ft x 10 ft)

Side View
Standard Long Range: 61 m x 3 m (200 ft x 10 ft)

Top View
Optional Long Range 37 m x 8 m (120 ft x 26 ft)

Side View
Optional Long Range 37 m x 8 m (120 ft x 26 ft)

Standby Power
If there is no internal standby battery, connect to DC power
source capable of supplying standby power if the primary
power fails.

Model

Standby Power

mAh required per hour

DS794Z

No standby battery

18 mAh

DS794ZE

No standby battery

25 mAh

DS794ZE-FRA

No standby battery

18 mAh

ZX794Z

Provided by the Zonex

bus

0.5 mAh

Note

A minimum of four hours of standby power is
required for UL Listed requirements.

Parts Included

For your convenience, the OA200 Mirror and OA80 Mirror
are included with the detector.

Technical Specifications

Enclosure

Dimensions:

14 cm x 21 cm x 14 cm

(5 in. x 7.5 in. x 5 in.)

Material:

High impact ABS plastic enclosure

Environmental Considerations

Operating Tem-

perature:

-29°C to +49°C (-20°F to +120°F)

For UL Certificated installations, 0°C to +49°C (+32°F to

+120°F)

Radio Frequency

Interference

(RFI) Immunity:

No alarm or setup on critical frequencies in the range

from 26 MHz to 950 MHz at 50 V/m.

DS794ZE:

Complies with Environmental Class II (EN50130-5)

Mounting

Height:

5 m (15 ft.) maximum

Location:

Surface or corner

Power Requirements

Current Draw:

18 mA at 12 VDC

25 mA at 12 VDC (DS794ZE)

Voltage (Input):

6 VDC to 15 VDC

ZX794Z: Power comes from two-wire Zonex Bus.

<0.5 mA nominal, 2 mA in alarm with LEDs enabled.

Do not leave Walk Test LEDs enabled.

Outputs

Alarm:

ZX794Z: Signal through POPIT data bus.

DS794ZE-FRA: Form C Contacts rated at 3.0 W, 125 mA at

28 VDC for resistive loads protected by a 4.7 Ω resistor in the

common C leg.

Tamper:

Normally-closed (with cover in place). Contacts rated at

28 VDC, 125 mA maximum.

ZX794Z: Signal through POPIT data bus. Signaled as Missing.

Trouble:

Solid state output, shorts to negative when activated. Maxi-

mum current load is 25 mA.

ZX794Z: Signal through POPIT data bus.

Trademarks

Sonalert

®

is a registered trademark of Mallory Sonalert

®

Products, Inc.

Ordering Information

DS794Z Long‑Range PIR Intrusion Detector

Provides Motion Analyzer II processing, Motion

Monitor, and three coverage patterns, and

61 m x 3 m (200 ft x 10 ft) long range coverage.

DS794Z

DS794ZE‑FRA Long‑Range PIR Intrusion
Detector

For use in France. Provides Motion Analyzer II

processing, Motion Monitor, and three cover-

age patterns, and 61 m x 3 m (200 ft x 10 ft)

long range coverage.

DS794ZE-FRA

Accessories

OA120‑2 Mirror

A 36.5 m (120 ft) optical array module. Ship-

ped in packages of two.

OA120-2

Bosch Security Systems B.V.

www.boschsecurity.com

5

Advertising