Bosch 8-Dec - Manual (Page 481)

DSRF Premises Wireless | Bosch DSRF Transmitters | 473
RF940E Wireless PIR
Detector
The RF940E is a high performance PIR motion sensor that
uses advanced signal processing to provide outstanding
catch performance and unsurpassed false alarm immunity.
The RF940E’s pet immunity tolerates pets and animals such
as a dog up to 13 kg, two cats, or numerous rodents. The
detector contains an integral RF transmitter capable of
transmitting up to 300 m in open air. The transmitter sends
a battery report with each transmission and transmits a
supervisory signal to the control panel every thirteen
minutes.
Note Actual acceptable transmitter range should be
verified for each installation.
Certifications and Approvals
Region Certification
Europe CE 1999/5/EC, EN60950 1992 (2nd edition)
+A1 (1993) +A2 (1993) +A3 (1995) +A4
(1997), EN55022-1 Class B (1999),
EN55024 (1998), EN50130-4 (1995)
+A1 (1998) +A2 (2003), EN61000-4-2
(1995), EN61000-4-3 (1997),
EN61000-4-4 (1995), EN61000-4-5
(1995), EN61000-4-6 (1997),
EN61000-4-8 (1994), EN61000-4-11
(1994), EN301489-3 (2000),
ETS300683 (1997), EN300222-1
(1997-99), EN300220-3 (1997-99)
1999/5/EC, EN60950: 1993 +A1 +A2
+A3 +A4, EN300220-1: 1997,
EN300683: 1997
China CCC 2008031901000108
Brazil ANATEL 0254-06-1855
Europe Complies with EN50131‑1, Grade 2
Installation/Configuration Notes
Compatibility Information
The RF940E detector is compatible with the following
combinations of receivers and control panels:
Receivers Control Panels
RF3212E Solution Ultima 844, 862, and 880 control panels,
CC488 control panels
RF3213E VR-8 control panels
RF3222E DS7400XiV4 control panels
RF3227E DS7240, CC7240-A Solution 40 control panel
RF3228E Marise control panels
RF3249E DA (Abacus) control panels
Mounting Considerations
Surface or corner mount (with or without the optional
bracket) at a height between 2.3 m and 2.7 m high.
• The maximum wireless range of the detector, in open
air, is approximately 300 m. In normal household or
commercial applications, keep the detector within
100 m of the assigned control panel receiver.
•
Temporarily mount the detector using double-sided
tape, and test it for both detector coverage and RF
range from the desired location before mounting it
permanently.
•
Mount the detector where an intruder will most likely
cross through the coverage pattern.
•
Do not mount in areas with large metallic surfaces such
as heating ducts or electrical wiring which may inhibit
the sensor’s RF signals from reaching the control panel
receiver.
• Do not mount the detector outdoors or where direct
sunlight can reach it.
•
In pet immune applications, do not mount where pets
can climb because the upper areas are not immune to
pets.
Note Optional mounting brackets can reduce the
range and increase dead zone areas. Do not
use brackets in pet immune applications.
Battery Recommendations
The following battery types are recommended for correct
operation of your detector: Duracell® DL123A, Energizer®
EL123AP, or Panasonic® CR123A.
www.boschsecurity.com Bosch Security Systems B.V.
9