Bosch 8-Dec - Manual (Page 295)

Detectors and Accessories | Accessories | 287
Side View
1 Camera's viewable area
2 PIR coverage pattern
3 Look-down zone
Note The passive-infrared (PIR) coverage patterns
and look-down zone depend on the specific
detector used. Refer to the detector's
datasheet.
Note A pair of masks are provided to reduce the
detector's PIR coverage area since that area is
larger than the camera's field of view.
Power Considerations
Power Limits
Input power must be provided by an Approved Limited
Power Source. All outputs must be connected to SELV
(safety extra-low voltage) circuits only.
Standby Power
This detector has no internal standby battery. For UL Listed
product installations, 4 hr (20 mAh with camera off, 460 mAh
with camera on) of standby power must be supplied by the
control unit or by a UL Listed burglary power supply.
Video Connection
A video cable with a BNC connector at one end is supplied.
Connect this cable to up to 152 m (500 ft) of 75 Ω RG59/U
or similar coaxial cable.
Parts Included
Quant. Component
1 Camera module
1 Mask
1 Hardware pack
1 Literature pack
Technical Specifications
Environmental Considerations
Complies with EN50131 Environmental Class II, Security Grade 2
Relative Humidity:
0 to 85%, non-condensing
Temperature (operating): -10°C to +49°C (+14°F to +120°F) For UL
Listed product installations, 0°C to +49°C
(+32°F to +120°F)
Input
Alarm: 5 V normally from sensor digital alarm output, ground for 4 sec
during alarm.
Mechanical Properties
Color: White
Dimensions: 5.6 cm x 6.1 cm x 4.8 cm
(2.2 in. x 2.4 in. x 1.9 in.)
Material: High-impact ABS plastic
Radio Frequency In-
terference (RFI) Im-
munity:
No alarm or setup on critical frequencies in the range
from 26 MHz to 2 GHz at field strengths less than 30 V/
m.
Outputs
Relay Timer: Selectable latch time of 15 sec or 90 sec.
Timed Relay: Solid state, selectable supervised Form A normally-
closed (NC) or unsupervised Form B normally-open (NO)
contacts rated for 125 mA, 28 VDC, 3 W.
Tamper: Normally-closed (NC) contacts (with cover on) rated at
28 VDC, 125 mA maximum. Connect to detector tamper
circuit.
Power Requirements
Current (Alarm): 115 mA when camera is on
Current (Standby): 5 mA maximum at 12 VDC
Voltage (Operating): 12 VDC nominal
Video
CCD: 8.5 mm (1/3-inch) color with an electronic
shutter
Field of view: 66° horizontal, 53° vertical
Lens: 3.6 mm fixed focal length lens
Resolution (horizontal): 330 lines minimum at center of picture
Scanning System: 2:1 interlaced
Sensitivity: <3 lx
Signal: 75 Ω (NTSC or PAL)
Signal to Noise Ratio: 45 dB minimum
Ordering Information
ISM‑BLA1‑CC Blue Line Color Camera
Module (NTSC format)
NTSC format
ISM-BLA1-CC-N
ISM‑BLA1‑CC Blue Line Color Camera
Module (PAL format)
PAL format
ISM-BLA1-CC-P
www.boschsecurity.com Bosch Security Systems B.V.
5