Leica Biosystems ASP6025 - Manual (Page 68)

66 Instructions for Use V 2.2 RevI – 08/2013
5. Operation
The INSTALLATION menu
(continued)
Upgrading software
Installing help
Fig. 76

In order to be able to install the help file, the associated file must
be present as a ZIP file on a USB stick.
• Plug in the USB stick and press the INSTALL HELP button.
• Then, follow the instructions on the screen and confirm
them as necessary. The system will automatically unpack
and install the files.
Fig. 77

There are two possible ways to update the software:
1. Using the Remote Care function:
In this case, a message appears indicating that a software
update is available.
• Confirm this and follow the instructions on the screen.
Calibrating the touchscreen ( Fig. 78 )
Fig. 78

2. The software update is delivered on a USB stick:
• Connect the USB stick and press the UPGRADE SOFTWARE button (
Fig. 77 ).
• Then, follow the instructions on the screen and confirm them as necessary.
This function is a guided calibration in which various items must be pressed on the screen.
To call up the screen for this, press the CALIBRATE TOUCHSCREEN button (top figure).
• Touch the red circle in the middle of the screen (three times in total), starting in the upper-
left corner ( Fig. 78, top ).
• Then touch any point on the screen and check that the cursor follows the movement
( Fig 78, bottom ).
• If the cursor moves to the position you have touched, end calibration by touching the green
check mark. Otherwise, return to the first step of the calibration process and repeat the
procedure.
