Lenze EtherCAT Controller-based Automation - Manual (Page 108)

8 Mixed operation - EtherCAT with other bus systems
8.2 PROFIBUS as the logic bus and EtherCAT as a logic bus or motion bus
108
Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 PROFIBUS as the logic bus and EtherCAT as a logic bus or motion bus
[8-2] Example: Mixed operation of EtherCAT with PROFIBUS connected to a 3231 C controller with Servo-Inverter i700 and Servo
Drives 9400

Note!
In the Lenze automation system, only the PROFIBUS master functionality (Logic Bus) is
supported.
The Motion functionality is not supported when PROFIBUS is used. Always use EtherCAT
to connect inverters to be controlled via the central motion functionality.

Communication manual for Controller-based Automation with PROFIBUS
Here you can find information on how to commission PROFIBUS components.