7 configuring the communication parameters, Configuring the communication parameters, Configuring the communication parameters ( 73) – Lenze EtherCAT Controller-based Automation User Manual
Page 73: 7commissioning of the system
Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17
73
7
Commissioning of the system
7.3
Detailed description of the commissioning steps
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.3.7
Configuring the communication parameters
Set the communication parameters in order to be able to carry out a fieldbus scan at a later time or
in order to be able to establish an online connection to the Lenze Controller .
How to configure the communication parameters
1. Go to the Communication settings tab of the target system (device) and click the
Add
gateway button.
Then go to the Gateway dialog box and enter the
IP address of the controller. (By
double-clicking the predefined value it can be overwritten.)
2. Confirm the entry by clicking OK.