Lenze EtherCAT Controller-based Automation - Manual (Page 196)

13 Parameter reference
196
Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13 Parameter reference
This chapter complements the parameter list of the online help for the Lenze Controller by the
parameters of the EtherCAT communication interface.
These parameters ...
• are for instance shown in the Lenze »WebConfig« (Engineering tool for web-based
parameterisation);
• are listed in numerically ascending order.
C280/4
C281/2
Parameter | Name:
C280/4 | ECAT bus scan compliance
Data type: UNSIGNED_8
Index: 24295.4 =
0x5EE7.0x04
Brief information on whether the master configuration corresponds to the physical bus structure. The master
configuration of the stack is compared to the actual bus structure.
Selection list
(Lenze setting printed in bold)
Info
0 No match The master configuration does not correspond to the bus
structure.
1 OK The master configuration corresponds to the bus
structure.
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C281/2 | ECAT master: State
Data type: UNSIGNED_8
Index: 24294.2 =
0x5EE6.0x02
Display of the current master state
Selection list
(read only)
0 Unknown
1 Init
2 Pre-operational
3 Bootstrap Mode
Bootstrap mode is not supported.
4 Safe-operational
8 Operational
 Read access  Write access  CINH  PLC-STOP  No transfer