Lenze EtherCAT Controller-based Automation - Manual (Page 164)

12 Diagnostics
12.1 Diagnostics with the »PLC Designer«
164
Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.1.2 Diagnostic tabs of the EtherCAT master
Only if an online connection to the Lenze Controller has been established, information is displayed
in the diagnostic tabs.
The following information is displayed on the Diagnostic Master tab:
• Error occurred last
• Number of emergency frames
• Status information
• Information on "Distributed clocks"
• Information on network topology
• Frame and error counter
In addition to the EtherCAT states, the Diagnostic Slaves tab also displays the positions, addresses,
and names of the EtherCAT nodes: