Lenze EVF9383 - Manual (Page 15)

Configuration
Basic configuration
2−7
l
EDSVF9383V−EXT EN 2.0
2.2.3 Speed control (C0005 = 1000)
The configuration C0005 = 1000 (Lenze setting) has mainly been designed for single drives. The
setpoint speed for the drive is selected via the analog input X6/1. The signals are internally
conditioned together with the digital control signals.
Short setup
The "Short setup" menu contains the following codes. In the "Short setup" menu of the XT keypad
and "Global Drive Control", the codes are listed in the following order.
Code Explanation Lenze setting
C0005 Selection of the basic configuration 1000
C0010 Minimum speed Reference value for the absolute and relative setpoint selection for the
acceleration and deceleration times 0 rpm
C0011 Maximum speed 3000 rpm
C0012 Acceleration time T
ir
of the main setpoint 5.00 s
C0013 Deceleration time T
if
of the main setpoint 5.00 s
C0034 Voltage / current range for analog signals at the input X6/1, X6/2 0
C0104 Selection of acceleration function of the linear ramp−function generator of NSET 0
C0038/1 ... C0038/6 Suppressing the speed ranges, function block NLIM1 0
C0039/1 JOG setpoints for the speed setpoint conditioning, function block NSET 1500 rpm
C0190 Arithmetic function, function block NSET
Connects main setpoint (C0046) and additional setpoint (C0040) 0
C0220 Acceleration time T
ir
for additional setpoint, function block NSET 2.00 s
C0221 Deceleration time T
if
for additional setpoint, function block NSET 2.00 s
C0105 Quick stop deceleration time 5.00 s
C0909 Speed limitation, function block MCTRL 1
C0026/1 Offset of AIN1 (X6/1, X6/2) 0.00 %
C0026/2 Offset of AIN2 (X6/3, X6/4) 0.00 %
C0027/1 Gain AIN1 (X6/1, X6/2) 100.00 %
C0027/2 Gain AIN2 (X6/3, X6/4) 100.00 %
C0006 Selection of the operating mode for the motor control 5
C0025 Speed feedback 1
C0019 Operating threshold − automatic DC injection brake (Auto−GSB) 0 rpm
C0036 Set continuous brake current 0.0 A
C0107 Hold time for automatic DC injection braking (Auto−GSB) 0.00 s
C0142 Start conditions for flying restart circuit 1
C0145 Selection of flying restart method 1
C0070 Speed controller gain 10.0
C0071 Adjustment time of speed controller 50 ms
C0074 Limitation of the speed controller 10.00 %
C0077 Adjustment time of field controller 4.0 ms
C0898 Torque limitation in the field weakening range, function block MCTRL 0
C0472/3 Free control code for analog signals 100.00%
C0017 Q
min
switching threshold 50 rpm