Lenze EVF9383 - Manual (Page 25)

Configuration
Basic configuration
2−17
l
EDSVF9383V−EXT EN 2.0
2.2.7 Digital frequency − master (C0005 = 5000)
The configuration C0005 = 5000 is used to control a drive system. Both the master and the slave
drives use the preprocessed speed setpoint as a common reference value. The speed setpoint is
forwarded to the slave drives via digital frequency output X10.
The parameterisation of the evaluation of the reference value allows you to adapt the speed ratio of
every single drive to the process.
Fig. 2−10 shows the basic structure of a digital frequency network for textile machinery.
Short setup
The "Short setup" menu contains the following codes. In the "Short setup" menu of the XT keypad
and "Global Drive Control", the codes are listed in the following order.
Code Explanation Lenze setting
C0005 Selection of the basic configuration 5000
C0010 Minimum speed Reference value for the absolute and relative setpoint selection for the
acceleration and deceleration times 0 rpm
C0011 Maximum speed 3000 rpm
C0012 Acceleration time T
ir
of the main setpoint 5.00 s
C0013 Deceleration time T
if
of the main setpoint 5.00 s
C0034 Voltage / current range for analog signals at the input X6/1, X6/2 0
C0039/1 JOG setpoints for speed setpoint conditioning, function block NSET 1500 rpm
C0190 Arithmetic function, function block NSET
Connects main setpoint (C0046) and additional setpoint (C0040) 0
C0220 Acceleration time T
ir
for additional setpoint, function block NSET 2.00 s
C0221 Deceleration time T
if
for additional setpoint, function block NSET 2.00 s
C0105 Quick stop deceleration time 5.00 s
C0909 Speed limitation, function block MCTRL 1
C0026/1 Offset of AIN1 (X6/1, X6/2) 0.00 %
C0026/2 Offset of AIN2 (X6/3, X6/4) 0.00 %
C0027/1 Gain AIN1 (X6/1, X6/2) 100.00 %
C0027/2 Gain AIN2 (X6/3, X6/4) 100.00 %
C0473/1 Numerator Digital frequency signal evaluation, function block DFSET C0473/1 = 1
C0533 Denominator C0533 = 1
C0530 Setpoint integrator evaluation, function block DFSET 0
C0032 Numerator Gearbox factor, function block DFSET C0032 = 1
C0033 Denominator C0033 = 1
C0252 Phase offset for master frequency processing, function block DFSET 0 inc
C0253 Speed−dependent phase trimming for the master frequency processing, function block DFSET 18700 inc
C0531 Actual zero pulse divisor, function block DFSET 1
C0535 Desired zero pulse divisor, function block DFSET 1
C0532 Zero pulse / touch probe, function block DFSET 1
C0534 Zero pulse function, function block DFSET
(drive synchronisation) 0
C0529 Offset multiplier, function block DFSET 1
C0472/5 Free control code for analog signals 0.00 %
C0473/3 Free control code for absolute analog signals 0
C0030 Constant for digital frequency output X10, function block DFOUT 3
C0540 Function selection, function block DFOUT 0
C0545 Phase offset, function block DFOUT 0 inc