Lenze EVF9383 - Manual (Page 32)

Configuration
Basic configuration
2−24
l
EDSVF9383V−EXT EN 2.0
2.2.10 Dancer position control with external diameter detection (C0005 = 8000)
The configuration C0005 = 8000 is designed for winding drives with dancer position control and
external diameter detection.
A digital frequency signal is sent for precontrolling the drive with the system/material speed. On the
basis of the actual position of the dancer, the dancer position controller generates a correction signal
which is added to the precontrol signal. This results in a circumferential speed setpoint which, in the
case of a surface winder, can be applied directly as the speed setpoint.
On a centre winding machine, the speed setpoint is obtained by evaluating the reel diameter. The
analog signal generated by the diametrical sensor is preprocessed accordingly inside the controller.
Short setup
The "Short setup" menu contains the following codes. In the "Short setup" menu of the XT keypad
and "Global Drive Control", the codes are listed in the following order.
Code Explanation Lenze setting
C0005 Selection of the basic configuration 8000
C0011 Maximum speed Reference value for the absolute and relative setpoint selection for the
acceleration and deceleration times 3000 rpm
C0034 Voltage / current range for analog signals at the input X6/1, X6/2 0
C0425 Digital frequency input constant, function block DFIN 3
C0427 Digital frequency input function, function block DFIN 0
C0141 Dancer position setpoint 10.00 %
C1330 Acceleration time t
ir
, function block PCTRL2 1.0 s
C1331 Deceleration time t
if
, function block PCTRL2 1.0 s
C1332 Gain V
p
, function block PCTRL2 1.0
C1333 Integral−action time T
n
, function block PCTRL2 400 ms
C1334 Differential component K
d
, function block PCTRL2 0.0
C1335 Sphere of action, function block PCTRL2 0
C1336 Fade−in time, function block PCTRL2 0.1 s
C1337 Fade−out time, function block PCTRL2 0.1 s
C0472/1 Influence, function block PCTRL2 10.00 %
C0026/1 Offset of AIN1 (X6/1, X6/2) 0.00 %
C0026/2 Offset of AIN2 (X6/3, X6/4) 0.00 %
C0027/1 Gain AIN1 (X6/1, X6/2) 100.00 %
C0027/2 Gain AIN2 (X6/3, X6/4) 100.00 %