Lenze EVF9383 - Manual (Page 91)

Configuration
2−83
l
EDSVF9383V−EXT EN 2.0
Signal Source Note
Name Type DIS DIS format CFG List Lenze
DCTRL−CINH1 d C0878/1 bin C0870/1 2 1000 HIGH = inhibit controller
DCTRL−CINH2 d C0878/2 bin C0870/2 2 1000 HIGH = inhibit controller
DCTRL−TRIP−SET d C0878/3 bin C0871 2 54 HIGH = fault indication EEr
DCTRL−TRIPRESET d C0878/4 bin C0876 2 55 LOW−HIGH signal = Trip reset
DCTRL−PAR*1 d C0884/1 bin C0880/1 2 1000 Select parameter set
DCTRL−PAR*2 d C0884/2 bin C0880/2 2 1000 Select parameter set
DCTRL−PAR−LOAD d C0884/3 bin C0881 2 1000 LOW−HIGH signal = Load parameter set
DCTRL−RDY d − − − − − HIGH = Ready for operation
DCTRL−CINH d − − − − − HIGH = Controller reset
DCTRL−IMP d − − − − − HIGH = High−resistance power output
stages
DCTRL−TRIP d − − − − − HIGH = Active fault
DCTRL−WARN d − − − − − HIGH = Active warning
DCTRL−MESS d − − − − − HIGH = Active message
DCTRL−FAIL d − − − − − −
DCTRL−CW/CCW d − − − − − LOW = CW rotation, HIGH = CCW rotation
DCTRL−NACT=0 d − − − − − HIGH = Motor speed < C0019
DCTRL−STAT*1 d − − − − − general status (binary coded)
DCTRL−STAT*2 d − − − − − general status (binary coded)
DCTRL−STAT*4 d − − − − − general status (binary coded)
DCTRL−STAT*8 d − − − − − general status (binary coded)
DCTRL−INIT d − − − − − −
DCTRL−PARBUSY d − − − − HIGH = Change of parameter set active
DCTRL−PAR*1−O d − − − − − Parameter set X active (binary coded)
DCTRL−PAR*2−0 d − − − − − Parameter set X active (binary coded)
Range of functions
l Quick stop (QSP)
l Operation inhibited (DISABLE)
l Controller inhibit (CINH)
l TRIP−SET
l TRIP−RESET
l Changing the parameter set (PAR)
l Controller state
2.4.22.1 Quick stop (QSP)
If QSP is activated, the drive is decelerated to zero speed via the deceleration ramp C0105.
l QSP is activated via three inputs:
– Control word CAN−CTRL.B3 from CAN−IN1
– Control word AIF−CTRL.B 3 from AIF−IN
– Control word C0135.B3
l All inputs are linked by an OR−operation
l QSP can also be activated via the input MCTRL−QSP in the FB MCTRL.