Lenze EVF9383 - Manual (Page 17)

Configuration
Basic configuration
2−9
l
EDSVF9383V−EXT EN 2.0
2.2.4 Step control (C0005 = 2000)
The configuration C0005 = 2000 supports applications in which the drive should repeatedly turn a
specific number of revolutions. This type of application is used for example to move unit loads on a
conveyor belt or for dosing specific amounts repeatedly on worm conveyors.
The conveyor speed and path or dosing speed and amount are controlled independently of one
another via the two analog inputs. The execution of a step is started via the digital input X5/E4.
Short setup
The "Short setup" menu contains the following codes. In the "Short setup" menu of the XT keypad
and "Global Drive Control", the codes are listed in the following order.
Code Explanation Lenze setting
C0005 Selection of the basic configuration 2000
C0010 Minimum speed Reference value for the absolute and relative setpoint
selection for the acceleration and deceleration times 0 rpm
C0011 Maximum speed 3000 rpm
C0012 Acceleration time T
ir
of the main setpoint 1.00 s
C0013 Deceleration time T
if
of the main setpoint 1.00 s
C0034 Voltage / current range for analog signals at the input X6/1, X6/2 0
C0104 Selection of acceleration function of the linear ramp−function generator of NSET 0
C1350 Function selection, function block INT1 0
C1351 Scaling factor, function block INT1 6553600 inc
C0560/1 Internal path setpoint (fixed setpoint), function block FIXSET1 100.00 %
C0940 Adaptation of the braking
distance [C0940]
[C0941]
+ [C0011] @ [C013] @ 65536
120 @ [1351]
C0940 = 1
C0941 C0941 = 4
C0105 Quick stop deceleration time 5.00 s
C0019 Operating threshold − automatic DC injection brake (Auto−GSB) 0 rpm
C0036 Set continuous brake current 0.0 A
C0107 Hold time for automatic DC injection braking (Auto−GSB) 0.00 s
C0026/1 Offset of AIN1 (X6/1, X6/2) 0.00 %
C0026/2 Offset of AIN2 (X6/3, X6/4) 0.00 %
C0027/1 Gain AIN1 (X6/1, X6/2) 100.00 %
C0027/2 Gain AIN2 (X6/3, X6/4) 100.00 %