Lenze EVF9383 - Manual (Page 23)

Configuration
Basic configuration
2−15
l
EDSVF9383V−EXT EN 2.0
2.2.6 Torque control (C0005 = 4000)
Configuration C0005 = 4000 is designed for drive control via a torque setpoint.
The setpoint is selected via the analog input X6/2. The torque direction results from the sign of the
setpoint and the control of the digital inputs X5/E1 and X5/E2. The maximum permissible speed is
selected via the analog input X6/1.
Short setup
The "Short setup" menu contains the following codes. In the "Short setup" menu of the XT keypad
and "Global Drive Control", the codes are listed in the following order.
Code Explanation Lenze setting
C0005 Selection of the basic configuration 4000
C0010 Minimum speed Reference value for the absolute and relative setpoint selection for the
acceleration and deceleration times 0 rpm
C0011 Maximum speed 3000 rpm
C0012 Acceleration time T
ir
of the main setpoint 5.00 s
C0013 Deceleration time T
if
of the main setpoint 5.00 s
C0034 Voltage / current range for analog signals at the input X6/1, X6/2 0
C0039/1 JOG setpoints for the speed setpoint conditioning, function block NSET 1500 rpm
C0105 Quick stop deceleration time 5.00 s
C0909 Speed limitation, function block MCTRL 1
C0026/1 Offset of AIN1 (X6/1, X6/2) 0.00 %
C0026/2 Offset of AIN2 (X6/3, X6/4) 0.00 %
C0027/1 Gain AIN1 (X6/1, X6/2) 100.00 %
C0027/2 Gain AIN2 (X6/3, X6/4) 100.00 %
C0006 Selection of the operating mode for the motor control 5
C0022 I
max
limit in motor mode depends on the
controller
C0023 I
max
limit in generator mode depends on the
controller
C0025 Speed feedback 1
C0070 Speed controller gain 10.0
C0071 Adjustment time of speed controller 50 ms
C0074 Limitation of the speed controller 10.00 %
C0898 Torque limitation in the field weakening range, function block MCTRL 0
C0472/3 Free control code for analog signals 100.00 %
C0017 Q
min
switching threshold (FCODE) 50 rpm