Rockwell Automation 23P PowerFlex Digital DC Drive - Manual (Page 371)

Rockwell Automation Publication 20P-UM001K-EN-P - July 2014 371
Installing a Communication Adapter Appendix E
Frame D
a. Loosen, but do not remove, the Hexalobular head screws that secure the
cover, containing the HIM cradle, to the drive frame. Then, slide the
cover up until the screw heads line up with the key holes and lift the
cover off the chassis.
4. Disconnect the HIM Communication cable from the connector on the
upper right corner of the control board and set the cover aside.
IMPORTANT The HIM assembly is connected to the control board by a cable and
therefore will not pull free from the drive until disconnected. See step 4
below for instructions.
Disconnect DPI cable.
=
Pull tabs out to
disconnect cable.
=
All Frames (Frame A shown)