Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 102)

9-48 MD65 AC Drive User Manual
Displays the output frequency scaled by Process Factor (A099).
Output Frequency x Process Factor = Process Display
Displays the active source of the Start Command and Speed
Command, which are normally defined by the settings of Start
Source (P036) and Speed Reference (P038) but may be overridden
by digital inputs. Refer to the flowcharts in sections 6.6 and 6.7 for
details.
d010 Process Display
Range: 0.00 to 9999
Default: Read Only
See also: d001, A099
32
d012 Control Source
Range: 0 to 9
See figure 9.16.
Default: Read Only
See also: P036, P038, A051-A054
Figure 9.16 – Control Source (d012) Bit Definitions
Start Command Digit 0
0 = Keypad
1 = 3-Wire
2 = 2-Wire
3 = 2-Wire Level Sensitive
4 = 2-Wire High Speed
5 = RS485 Port
9 = Jog
Speed Command Digit 1
0 = Drive Potentiometer
1 = Internal Freq (A069)
2 = 0-10 V Input/Remote Potentiometer
3 = 4-20 mA Input
4 = Preset Freq x (A070-A077)
Digital Inx Sel (A051-A050) must be set to 4
5 = RS485 Port
6 = StepLogic
TM Control (A140-A147)
9 = Jog Freq
Reserved Digit 2
Reserved Digit 3