Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 88)

9-34 MD65 AC Drive User Manual
Scales the time value when the drive is running at Maximum Freq
(P035). When set to a value other than zero, Process Display
(d010) indicates the duration of the process.
Disables the bus regulator.
Maximum output current allowed before current limiting occurs. This
parameter is only active if Digital Inx Sel (A051-A054) is set to 25 =
Current Lmt2 and is active.
Sets the center of a frequency band at which the drive will not
operate continuously (also called an avoidance frequency). A
setting of 0 disables this parameter.
Determines the bandwidth around Skip Frequency (A119); half the
band above and half the band below the skip frequency. Refer to
figure 9.12.
A116 Process Time Hi
Range: 0.00 to 99.99
Default: 0.00
See also: d010, P035
A117 Bus Reg Mode
Range: 0 = Disabled
1 = Enabled
Default: 1 = Enabled
See also: N/A
A118 Current Limit 2
Range: 0.1 to Drive Rated Amps x 1.8
Default: Drive Rated Amps x 1.8
See also: P033, A051-A054, A089
A119 Skip Frequency
Range: 0 to 400 Hz
Default: 0 Hz
See also: A120
A120 Skip Freq Band
Range: 0.0 to 30.0 Hz
Default: 0.0 Hz
See also: A119