Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 125)

Record of User Settings B-3
A084 Boost Select 8 = 5.0, CT
7 = 2.5, CT (for
5.0, 7.5, and
10.0 HP drives
only) 9-23
A085 Start Boost 5.0% 9-24
A086 Break Voltage 25.0% 9-24
A087 Break Frequency 15.0 Hz 9-25
A088 Maximum Voltage Drive Rated
Volts 9-25
A089 Current Limit 1 Drive Rated
Amps x 1.8 9-25
A090 Motor OL Select 0 = No Derate 9-25
A091 PWM Frequency 4.0 kHz 9-26
A092 Auto Rstrt Tries 0 9-26
A093 Auto Rstrt Delay 1.0 sec 9-27
A094 Start At PowerUp 0 = Disabled 9-27
A095 Reverse Disable 0 = Rev Enabled 9-27
A096 Flying Start En 0 = Disabled 9-28
A097 Compensation 1 = Electrical 9-28
A098 SW Current Trip 0.0 (Disabled) 9-28
A099 Process Factor 30.0 9-29
A100 Fault Clear 0 = Ready/Idle 9-29
A101 Program Lock 0 = Unlocked 9-29
A102 Testpoint Sel 400 9-29
A103 Comm Data Rate 4 = 19.2 K 9-30
A104 Comm Node Addr 1 9-30
A105 Comm Loss Action 0 = Fault 9-30
A106 Comm Loss Time 5.0 sec 9-31
A107 Comm Format 0 = RTU 8-N-1 9-31
A108 Language 1 = English 9-31
A109 Anlg Out Setpoint 0.0% 9-32
A110 Anlg In 1-10V Lo 0.0% 9-32
A111 Anlg In 0-10V Hi 100.0% 9-32
A112 Anlg In4-20mA Lo 0.0% 9-32
A113 Anlg In4-20mA Hi 100.0% 9-33
A114 Slip Hertz @ FLA 2.0 Hz 9-33
No. Parameter Name
Default
Value
Page
No. User Setting