Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 9)

Contents VII
List of Tables
Table 2.1 – Drive Ratings, Model Numbers, and Frame Sizes...................2-2
Table 2.2 – Standard Kits and Accessories ................................................2-3
Table 3.1 – Ambient Operating Temperatures and Mounting
Clearances.............................................................................3-2
Table 3.2 – Mounting Specifications ...........................................................3-6
Table 5.1 – Corrective Actions for Input Power Conditions ........................5-4
Table 5.2 – Power Wiring Specifications ....................................................5-4
Table 5.3 – Power Terminal Block Specifications.......................................5-5
Table 5.4 – Drive, Fuse, and Circuit Breaker Ratings.................................5-7
Table 5.5 – Shielded Motor Cable Types Acceptable for 200-600
Volt Installations.....................................................................5-9
Table 5.6 – Maximum Cable Length Recommendation............................5-10
Table 6.1 – Recommended Control and Signal Wire..................................6-3
Table 6.2 – I/O Terminal Block Specifications ............................................6-3
Table 6.3 – Control Terminal Definitions and Related Parameters.............6-5
Table 6.4 – Typical Multiple Drive Connection Examples...........................6-9
Table 8.1 – LED Descriptions .....................................................................8-2
Table 8.2 – Key Descriptions ......................................................................8-3
Table 8.3 – Viewing and Adjusting Basic (P) and Advanced (A)
Parameters ............................................................................8-5
Table 8.4 – Viewing the Display (d) Parameters.........................................8-6
Table 9.1 – Trip Points for Digital Output Relay........................................9-13
Table 9.2 – On/Off Points for the Opto Outputs........................................9-16
Table 9.3 – A064 Options .........................................................................9-17
Table 9.4 – Analog Output Signal Mode Selections .................................9-17
Table 9.5 – Selecting the Reference Source Using Presets.....................9-20
Table 9.6 – Related Parameters for Stp Logic Parameters
(A140-A147) ........................................................................9-41
Table 10.1 – Fault Descriptions and Corrective Actions ...........................10-3
Table 10.2 – Problem: Drive Does Not Start From Terminal Block
Start or Run Inputs.............................................................10-7
Table 10.3 – Problem: Drive Does Not Start From Integral Keypad .........10-8
Table 10.4 – Problem: Drive Does Not Respond to Changes in
Speed Command ...............................................................10-8
Table 10.5 – Problem: Motor and/or Drive Will Not Accelerate to
Commanded Speed .........................................................10-10
Table 10.6 – Problem: Motor Operation is Unstable...............................10-10
Table 10.7 – Problem: Drive Will Not Reverse Motor Direction ..............10-11