Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 129)

Parameters Cross-Referenced by Name C-1
A
PPENDIX
C
Parameters
Cross-Referenced
by Name
Parameter Name No.
Parameter
Group
Default
Value
Page
No.
10V Bipolar Enbl A123 Advanced 0 = Uni-Polar In 9-36
Accel Time 1 P039 Basic 5.0 sec 9-6
Accel Time 2 A067 Advanced 10.0 sec 9-18
Analog In 0-10V d020 Display Read Only 9-51
Analog In 4-20mA d021 Display Read Only 9-51
Analog In Loss A122 Advanced 0 = Disabled 9-35
Analog Out High A066 Advanced 100% 9-17
Analog Out Sel A065 Advanced 0 9-17
Anlg In 0-10V Hi A111 Advanced 100.0% 9-32
Anlg In 1-10V Lo A110 Advanced 0.0% 9-32
Anlg In4-20mA Hi A113 Advanced 100.0% 9-33
Anlg In4-20mA Lo A112 Advanced 0.0% 9-33
Anlg Out Setpoint A109 Advanced 0.0% 9-32
Auto Rstrt Delay A093 Advanced 1.0 sec 9-27
Auto Rstrt Tries A092 Advanced 0 9-26
Autotune A127 Advanced 0 = Ready/Idle 9-37
Boost Select A084 Advanced 8 = 5.0, CT
7 = 2.5, CT (for
5.0, 7.5, and
10.0 HP drives
only) 9-23
Break Frequency A087 Advanced 15.0 Hz 9-25
Break Voltage A086 Advanced 25.0% 9-24
Bus Reg Mode A117 Advanced 1 = Enabled 9-34
Comm Data Rate A103 Advanced 4 = 19.2 K 9-30
Comm Format A107 Advanced 0 = RTU 8-N-1 9-31