Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 112)

10-6 MD65 AC Drive User Manual
F100 Parameter
Checksum
N The checksum read
from the board does
not match the
checksum calculated.
Set Reset to Defalts
(P041) to 1 = Reset
Defaults.
F122 I/O Board Fail N Failure has been
detected in the drive
control and I/O section.
• Cycle power.
• Replace drive if fault
cannot be cleared.
1 Refer to section 10.1.2 for information about the Auto Restart Feature.
Table 10.1 – Fault Descriptions and Corrective Actions (Continued)
No. Fault A
uto-Re
set
1
?
Description Action