Rockwell Automation MD65 User Manual Version 2.0 - Manual (Page 126)

B-4 MD65 AC Drive User Manual
A115 Process Time Lo 0.00 9-33
A116 Process Time Hi 0.00 9-34
A117 Bus Reg Mode 1 = Enabled 9-34
A118 Current Limit 2 Drive Rated
Amps x 1.8 9-33
A119 Skip Frequency 0 Hz 9-34
A120 Skip Freq Band 0.0 Hz 9-34
A121 Stall Fault Time 0 = 60 sec 9-35
A122 Analog In Loss 0 = Disabled 9-35
A123 10V Bipolar Enbl 0 = Uni-Polar In 9-36
A124 Var PWM Disable 0 = Enabled 9-36
A125 Torque Perf Mode 1 = Sensrls Vect 9-37
A126 Motor NP FLA Drive Rated
Amps 9-37
A127 Autotune 0 = Ready/Idle 9-37
A128 IR Voltage Drop Based on Drive
Rating 9-38
A129 Flux Current Ref Based on Drive
Rating 9-38
A130 PID Trim Hi 0.0 9-38
A131 PID Trim Lo 0.0 9-39
A132 PID Ref Select 0 = PID Disabled 9-39
A133 PID Feedback Sel 0 = 0-10V Input 9-39
A134 PID Prop Gain 0.00 9-39
A135 PID Integ Time 0.0 sec 9-40
A136 PID Diff Rate 0.0 (1/sec) 9-40
A137 PID Setpoint 0.0% 9-40
A138 PID Deadband 0.0% 9-40
A139 PID Preload 0.0 Hz 9-40
A140 Stp Logic 0 00F1 9-41
A141 Stp Logic 1 00F1 9-41
A142 Stp Logic 2 00F1 9-41
A143 Stp Logic 3 00F1 9-41
A144 Stp Logic 4 00F1 9-41
A145 Stp Logic 5 00F1 9-41
A146 Stp Logic 6 00F1 9-41
A147 Stp Logic 7 00F1 9-41
No. Parameter Name
Default
Value
Page
No. User Setting