Hypertherm Phoenix 8.0 - Manual (Page 118)

Shape Manager
111
Cut Direction
Cut Direction allows to user to select the direction the parts will be placed in during the
automatic nesting process. Options are: Left or Right, Right to Left, Top to Bottom and
Bottom to Top.
Nest Direction
Select the direction in which nests are placed in the automatic nesting process.
Return to Nest Start
When enabled, the Return to Nest Start feature will insert a traverse segment back to the
start point at the end of the nest.
Use Remnant
If remnants are created and saved for future use, select On to use one of these remnants
for automatic nesting.
Generate and Cut Offcut
Select On to generate offcuts for standard, rectangular nests.
If this feature is enabled, offcuts are created when 30% or more of the sheet remains after
nesting. The offcut is cut after a pause at the end of the nest on the last nested rectangular
sheet.
M65 Auto Reload
Select On to allow new sheets to be reloaded automatically.
When this feature is selected, there is a pause at the end of each sheet until the operator
presses Start to Resume. Then, a new sheet automatically loads and runs. Auto reload
works with standard, rectangular nests only.