Hypertherm Phoenix 8.0 - Manual (Page 196)

Library Shapes
189
Flange Outer Radius
Enter the radius of the outside curved edge of the part.
Flange Inner Radius
Enter the radius of the inside curved edge of the part.
Slice Angle
Enter the angle of the straight sides of the part
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.