Hypertherm Phoenix 8.0 - Manual (Page 232)

Library Shapes
225
Left Width
Enter the width of the left side of the part.
Center Width
Enter the width of the center of the part.
Right Width
Enter the width of the right side of the part.
Top Height
Enter the height of the top of the part.
Center Height
Enter the height of the central portion of the part.
Bottom Height
Enter the height of the bottom portion of the part
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.