Hypertherm Phoenix 8.0 - Manual (Page 270)

Library Shapes
263
Base Width
Enter the width of the base of the part.
Height
Enter the height of the part.
Left Thickness
Enter the distance between the inner and outer edges on the left side of the part.
Top Thickness
Enter the distance between the inner and outer edges on the top of the part.
Right Thickness
Enter the distance between the inner and outer edges on the right side of the part.
Bottom Thickness
Enter the distance between the inner and outer edges on the bottom of the part.
Corner Selection
Use the dropdown list to select a corner of the part. Use the remaining fields to specify
the style of that corner. Repeat your selections for up to three corners.
Corner Type
Use the dropdown list to select a square, bevel, or round corner.
• If you select a bevel corner, use the Corner Width and Corner Height fields to enter
the dimensions of the bevel.
• If you select a round corner, use the Corner Radius field to enter the radius of the
corner.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.