Hypertherm Phoenix 8.0 - Manual (Page 337)

Password Setups
330
Machine
X Axis Orientation
Specifies the X axis as the transverse or rail axis. The default setting is Transverse. This
parameter should be set before cutting the part.
Up Direction
Defines the machine motion when the
↑ arrow key is pressed during manual mode.
Right Direction
Defines the machine motion when the
→ arrow key is pressed during manual mode.
Dual Gantry Installed
Select Yes to enable the dual gantry axis and allow configuration of that axis.
CBH Installed
Select Yes to enable the contour bevel head axis and allow configuration of that axis.
X and Y Motor/Encoder
Select Swapped to swap the X and Y Axis encoder signals internally. This feature
simplifies the installation of systems with alternative wiring configurations.