Hypertherm Phoenix 8.0 - Manual (Page 230)

Library Shapes
223
Base Width
Enter the width of the base of the part.
Top Width
Enter the width of the top of the part.
Overall Height
Enter the height of the part from the base to the top.
Side Height
Enter the height of the right side of the part. The height of this side must be less than the
height of the left side.
Corner Selection
Use the dropdown list to select a corner of the part. Use the remaining fields to specify
the style of that corner. Repeat your selections for up to three corners.
Corner Type
Use the dropdown list to select a square or bevel corner.
If you select a bevel corner, use the Corner Width and Corner Height fields to enter the
dimensions of the bevel.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.