Hypertherm Phoenix 8.0 - Manual (Page 184)

Library Shapes
177
Left Slant Width
Enter the width of the side that slants to the left.
Base Width
Enter the width of the base of the part.
Right Slant Width
Enter the width of the side that slants to the right.
Top Slant Height
Enter the height of the slanted sides on the top of the part.
Side Height
Enter the length of each side.
Bottom Slant Height
Enter the height of the slanted sides on the bottom of the part.
Lead In Radius
Enter the radius of the lead-in arc.
Lead Out Radius
Enter the radius of the lead-out arc.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.
Lead Type
Depending on the shape you select, the style of the lead in/ lead out can be selected as
radius, lock or straight line. The lock style lead-in creates greater stability for the part
and is only available if the part type is set to piece. Lead-in selection is only available if
the part type is set to piece or hole.
Note: Some shapes offer drop down fields to increase options with additional parameters.