Hypertherm Phoenix 8.0 - Manual (Page 268)

Library Shapes
261
Side Heights
Enter the diameter of the outside edges of the sides of the part.
Center Height
Enter the diameter of the outside, center edge of the part.
Outside Hole diameters
Enter the diameters of the outside holes within the part.
Center Hole Diameter
Enter the diameter of the center hole.
Corner Radius
Enter the radius of the curve in the corners of the part.
Outside Hole Offset
Enter the distance between the centers of the outside holes.
Lead In Radius
Enter the radius of the lead-in arc.
Overburn
Parts that contain a circular element user overburn. Overburn specifies the arc length that
the torch will travel past the circle closure point. The dimension entered is the chord
length of the overburn-arc.
In some cases it is desirable to have an underburn length. For these conditions, enter a
negative number for the overburn length.
Lead Out Radius
Enter the radius of the lead-out arc.
Lead Type
Depending on the shape you select, the style of the lead in/ lead out can be selected as
radius, lock or straight line. The lock style lead-in creates greater stability for the part
and is only available if the part type is set to piece. Lead-in selection is only available if
the part type is set to piece or hole.
Note: Some shapes offer drop down fields to increase options with additional parameters.