Hypertherm Phoenix 8.0 - Manual (Page 63)

Setups
56
HD3070 Auto Gas Interface
This section provides information on the Hypertherm HD3070
®
Auto Gas Interface. The
Auto Gas screen is available from the Cut Types screen.
Note: The Auto Gas feature must first be enabled at the Special Password screen and is
designed for use with the six valve autogas console only
The top of the Auto Gas screen lists the valve parameter settings for the HD3070. Valve
settings for the 3070 Auto Gas console are documented in the HD3070 manual. When
the values are set, these become the current setting and the operator can choose to save
the file to the diskette, USB memory stick or hard drive.
The settings at the supply are updated at control power up, whenever the settings are
changed at this screen or through commands in a part program Supply settings are also
updated if power is lost and re-enabled at the power supply. There may be a brief delay
as these power supply settings are communicated from the control to the power supply.
Save Data
Pressing the Save Data soft key will allow the operator to save the current Auto Gas
setting to diskette, USB memory stick or hard drive for future use.