Hypertherm Phoenix 8.0 - Manual (Page 238)

Library Shapes
231
Base Width
Enter the width of the base of the part.
Base Height
Enter the height of the part from the base to the top.
Left Concave Radius
Enter the length of the radius of the left concave side of the part.
Right Concave Radius
Enter the length of the radius of the right concave side of the part.
Top Concave Radius
Enter the length of the radius of the top concave side of the part.
Bottom Concave Radius
Enter the length of the radius of the bottom concave side of the part.
Corner Size
Enter the length and height of the corners of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.