Hypertherm Phoenix 8.0 - Manual (Page 346)

Password Setups
339
CBH Speed Setups
The CBH speed setup parameters display only if they have been enabled.
CBH Acceleration Rate
Specifies the acceleration rate for smooth and stable movement of the contoured bevel
head. The higher the acceleration rate, the quicker the CBH will get up to speed. The
lower the acceleration rate, the smoother the machine will position the cutting device.
Values are entered in revolutions/second
2
.
Maximum CBH Speed
Specifies the maximum speed for the CBH rotation in revolutions/minute.
CBH High Jog / Home Speed
Specifies the manual CBH jog and fast Home speed.
CBH Low Jog / Home Speed
Specifies the CBH slow home speed.
THC Speed Setups
The THC speed setup parameters display only if they have been enabled.
THC Acceleration Rate
Specifies the acceleration rate for smooth and stable movement of the Sensor THC. The
higher the acceleration rate, the quicker the THC will get up to speed. The lower the
acceleration rate, the smoother the machine will position the cutting device. Values are
entered in milliGs.
Maximum THC Speed
Specifies the maximum speed for the Sensor THC in inches / minute.
THC Jog Speed
Specifies the THC jog speed.
THC Home/Fast IHS Speed
Specifies the speed that is used to home the torch at the top of the slide and to move the
torch from the selected IHS height towards the plate, looking for the surface of the plate.
THC Slow IHS Speed
Specifies the speed that is used to retract the torch after the plate has been sensed. The
torch retracts at this speed until contact sense is lost. This determines the exact distance
to the plate regardless of any flexing of the plate. A very low speed is recommended for
optimal accuracy.
The following Speeds setup parameters are available when Tilt Rotator has been enabled.