Hypertherm Phoenix 8.0 - Manual (Page 474)

Program Codes
467
enabled. Unclamp/ Clamp and Unlock / lock commands execute a one second delay before
moving.
26B
Automatic Torch Spacing Program Codes
76B 76B 76B 76B
Code Description
M32 Unclamp / Unlock All Stations
M33 Unclamp / Lock All Stations
M34 Clamp / Unlock All Stations
M34Tvalue Clamp / Unlock ‘T” Station, where T = 1 through 19
M35 Clamp / Unlock All Stations Mirror
M35Tvalue Clamp / Unlock Mirror “T” Station, where T = 1 through 19
M77 Go to Home position Y Axis
M78 Go to Home position X Axis
G00 Xn Yn Traverse command where n = value to move the desired axes a distance.
27B
Automatic Torch Spacing I/O
Station Lock 1-19 The Station lock is used to Lock the unused torch station to the
gantry or beam when not in use.
Station Clamp 1-19
The Station Clamp is used to Clamp the selected torch station to
the transverse axis for standard cutting.
Station Mirror 1-19
Station Clamp is used to Clamp the selected torch station to the
transverse axis for mirrored cutting.
28B
Example Part Program
Transverse axis defined as X axis
Three station cut of 20 inch vertical rip.
57B 57B 57B 57B
CODE DESCRIPTION
G70 English Units
G91 Incremental Mode
G99 X1 Y0 I0 J0 Axes Preset zero Scaling
M32 Unclamp / Unlock All Stations
M78 Home X Axis (move all stations to Home position)
M34 Clamp All / Unlock All
G00X2Y0 Traverse X axis 2 inches (to move off edge/ switch)
M33 Unclamp All / Lock All
G00X10Y0 Traverse X axis 10 inches (to set 10 inch space – station 1)
M34 T1 Clamp Station 1 / Unlock Station 1
G00X10Y0 Traverse X axis 10 inches (to set 10 inch space– station 2)
M34 T2 Clamp Station 2 / Unlock Station 2
G41 Left Kerf
M07 Cut On
G01 X0 Y20 Line segment (Y axis 20 inches)
M08 Cut Off
G40 Kerf Off