Hypertherm Phoenix 8.0 - Manual (Page 262)

Library Shapes
255
Convex Diameter
Enter the diameter of the convex portion of the part.
Hole Width
Enter the width of the hole within the part.
Hole Height
Enter the height of the hole within the part.
Left Side to Hole
Enter the distance between the left corner of the base to the center of the hole.
Right Side to Hole
Enter the distance between the right corner of the base to the center of the hole.
Bottom to Hole
Enter the distance between the base and the center of the hole.
Side Height
Enter the height of the straight sides of the part.
Bottom Radius
Enter the radius of the curve on the bottom of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.