Hypertherm Phoenix 8.0 - Manual (Page 228)

Library Shapes
221
Base Width
Enter the width of the base of the part.
Top Width
Enter the width of the top of the part.
Overall Height
Enter the height of the part from the base to the top.
Side Height
Enter the height of the right side of the part. The height of the side must be less than the
overall height of the part.
Hole Diameter
Enter the diameter of the hole within the part.
Side to Hole
Enter the distance from the left side of the part to the center of the circle within it.
Top to Hole
Enter the distance from the top of the part to the center of the circle within it.
Lead In Radius
Enter the radius of the lead-in arc.
Overburn Length
Parts that contain a circular element user overburn. Overburn specifies the arc length that
the torch will travel past the circle closure point. The dimension entered is the chord
length of the overburn-arc.
In some cases it is desirable to have an underburn length. For these conditions, enter a
negative number for the overburn length.
Lead Out Radius
Enter the radius of the lead-out arc.