Hypertherm Phoenix 8.0 - Manual (Page 342)

Password Setups
335
Note: The drive I/O populates the general purpose I/O (both analog and digital) in order
from the lowest SERCOS drive axis to the highest SERCOS drive axis. All I/O is the
default setting for the SMCC interface.
RECO/Beckoff I/O at Address 50
Select Yes if the Indramat RECO or Bechkoff I/O module is being used to expand the
total number of I/O on the fiber optic ring.
Note: The RECO I/O will populate the general purpose I/O (both analog and digital)
following all drive I/O.
HPR/4070 at address 60
Select Yes if the optional SERCOS interface for HPR/4070 is being used.
HTA I/O at Address 70
Select Yes if the optional Hypertherm SERCOS interface card is being used.