Hypertherm Phoenix 8.0 - Manual (Page 278)

271
Part Options
There are a number of options available under the Part Options soft key. These options
can be used to customize the current part loaded into working memory. All options will
display the effects of the changes in the Preview Window.
Scale Factor
Allows the operator to scale the current part in memory by a programmed factor. After a
new scale factor has been entered, the part is redrawn and its overall dimensions shown.
The scale factor must be greater than zero.
Rotate Angle
Allows the operator to rotate the current part in memory by a programmed value. After a
new rotate angle has been entered, the new part is displayed in the Preview window. The
rotate angle can be any positive or negative angle.