Hypertherm Phoenix 8.0 - Manual (Page 403)

Password Setups
396
Format Floppy Disk
Formats a floppy disk if the CNC has difficulty reading a floppy disk formatted by a
computer.
Important: Formatting the diskette will remove any files that are stored on the diskette.
Reset Setups
Deletes the current setup file and reloads default values. A new setup file can then be
loaded on the CNC through the Special Password screen.
If the CNC supplier has installed a customized setup file that contains information
specific to the cutting table, the soft key is renamed Restore Setups. This custom setup
file is the default setup file and if you press the Restore Setup soft key, the custom setup
file is restored.