Hypertherm Phoenix 8.0 - Manual (Page 292)

Cut Operations
285
location displays and the screen may flash. Zoom out to correct this and view a larger
area.
Speed Increase
Increases the current cut speed by 3%.
Speed Decrease
Decreases the current cut speed by 3%.
Note: Double click the speed field to enter a new speed value.
Keyboard operation: To change the current cut speed while cutting a part, press the
Enter key once to highlight the current cut speed, enter the new cut speed, and press Enter
again.
Repeats
If a Shape Repeat option has been enabled, press the Repeats soft key to see the number
of rows and columns remaining to be cut. The Repeats soft key operates with the Extend
soft key which is only active during initiation of the cut sequence.
Cut Delay Timers
Cut Delay Timers define the timing logic for the cut and are available for both Oxy-fuel
and plasma at the Cut Types setup screen. In cut mode, the control displays the preset
delays as they are executed in the lower right corner of the screen. For certain delay
times, such as Preheat and Pierce, a countdown timer shows the preset time and time
remaining. An example of the Preheat Timer is illustrated below: