Hypertherm Phoenix 8.0 User Manual
Page 52
Setups
45
Press the Timing Diagram soft key to view the timing diagram from setups.
Ignition Time
Specifies the length of time that the oxy fuel igniter is held on at each ignition of the
flame.
Low Preheat
For those cutting systems that are equipped with a Low Preheat feature, this parameter
allows the operator to input a timing delay to activate the Low Preheat output prior to the
High Preheat.
High Preheat
Specifies the length of time to wait at each pierce position for preheating the piece prior
to piercing. During the run-time, the operator may use the SET, EXTEND, or RELEASE
soft keys to customize the preheat length for the particular metal being cut.
Pierce Time
Specifies the amount of delay after the cutting gas is turned on before lowering the torch
to the cut position.