Hypertherm Phoenix 8.0 - Manual (Page 47)

Setups
40
Process Select Override
When enabled, this feature allows the part program to override the process select input.
Station Select Override
When enabled, this feature allows the part program to override the currently selected
station select input.
Auto Torch Spacing Override
When enabled, this feature allows the part program to override the manually selected
torch spacing inputs.
G97 Loop Count Prompt
When enabled, this feature will post a message on the screen to enter the number of loops
or repeats to be selected when an EIA G97 code without a “T” value is encountered in the
part program.
ESAB Multi Torch Support
When enabled, this feature allows ESAB style ESSI part programs to map codes to
specific station selects.
Mapped
ESSI Code EIA Code Description
7 M37 T1 Select station 1
8 M38 T1 Deselect station 1
13 M37 T2 Select station 2
14 M37 T2 Deselect station 2
15 M37 T3 Select station 3
16 M38 T3 Deselect station 3
Force G40 Kerf Disable
In a part program, kerf is enabled and disabled using EIA G41/ G42 and G40 codes.
Standard operation is to disable kerf at the cut off even if the G40 kerf disable is not in a
program. With this parameter, you can turn off the “forced” G40 kerf disable if no G40
is used in the program by disabling the parameter.
G40 Used in Simple Shapes
This parameter is used with the Force Kerf Disable parameter to allow the G40 code that
is normally inserted in to a simple shape from the shape library to be omitted by disabling
the parameter.
Auto Start after APA
This parameter is used with the Automatic Plate Alignment feature to allow cutting to
begin automatically after completion of the automatic plate alignment.
EIA Code 2 Decimal Shift
Some programming styles are structured so that the decimal point in the EIA positioning
affecting part sizing is assumed. The EIA Code 2 Decimal Shift parameter allows the
operator to select the location of the decimal point when translating parts by selecting