Yaskawa FSP Amplifier FlexWorks - Manual (Page 193)

Command Reference
193
<N>
The number of points that are
going to be sent in the command.
<N> determine the number of
<Slave Delta> arguments.
Serial 1 U
S YNTAX
A RGUMENTS
<Slave Delta 1
- 4>
The relative distance between
each pair of slave points. <N>
determines the number of <Slave
Delta> arguments.
Serial 2
S EE A LSO ECAM_TABLE_BEGIN; ECAM_PROFILE;
ECAM_SEGMENT; ECAM_TABLE_END;
ECAM_PROFILE
S YNTAX ECAM_PROFILE <ID>
O P . C ODE 124
M ODES Immediate
D ESCRIPTION Each profile loading should start with this command,
which specifies the profile ID. The profile ID is used to
run that profile. Up to 4 profiles can be loaded.
S YNTAX
A RGUMENTS
<ID>
Long type . Up to 4 profiles can be loaded but
the ID can have be any number in the
range.
Serial 1 U
S EE A LSO ECAM_TABLE_BEGIN; ECAM_SEGMENT;
ECAM_POINTS; ECAM_TABLE_END