Yaskawa FSP Amplifier FlexWorks - Manual (Page 202)

Serial Interface Protocol
202
Description: Message Identification (two bytes for two digits). Since
the range is greater than 0xF, two bytes are required for holding the
number. Message Identification is needed to bind a fault condition to
a specific command and to enable download (new or replace) of FSP
Amplifier program lines.
I
D
1
AND
I
D
2
Range: 0x0 – 0xFF. 0x0 – 0xF each
M ESSAGE I DENTIFICATION
N UMBER
D ESCRIPTION
0x00 To ignore message identification
0x01 – 0xB4 Program line number (Program mode)
0xB5 – 0xC8 Message Identification (Immediate
and Sequential modes)
0xC9 – 0xFF For future use
N OTES :
Message ID enables rewriting of lines in FSP Amplifier
program. The program must be stopped prior to line
rewriting.
Message ID enables synchronization between status
received from FSP Amplifier and a specific message
Message ID may be ignored and set as 0x00.
Description: Command Operational Code (two bytes for two digits).
Because the range is greater than 0xF, two bytes are required for
holding the number.
C1
AND
C2
Range: 0x0 – 0xFF. 0x0 – 0xF each (see Chapter 11, List of
Operation Codes).